Led Lighting

Auxbeam Blog

  Links: Direct link to seller’s website: https://www.auxbeam.com/blog/ Direct link to product reviewed: 13.5” led light bar   This time we will try to... Auxbeam review: 13.5” PHILIPS led light bar



Direct link to seller’s website:


Direct link to product reviewed:

13.5” led light bar


This time we will try to install a 13.5” led light bar on the rear of the Jeep Wrangler as a reverse light.

Auxbeam 13.5 inch light bar

13.5″ led light bar

The 13.5 inch PHILIPS led light bar is available in Auxbeam.com, rated at 6000 lumens and a color temperature of 6000K. So what does most of that mean, here is the answer: lumen is the amount of visible light it gives off, a color temperature of 6000K means the light will be viewed as mostly white, as you go over the 6000 mark the light starts to turn blue.

It contains 12 pieces of Philips LED chips inside, 5W single chip and last for a long time. The housing is made of black die-cast aluminum, anti-corrosion and good cooling, durable for harsh environment. The mounting bracket is stainless steel, 2 tough angle-adjustable mounting holes per side make the installation easier for all kinds of vehicles. Configured in a single-row design with use specially designed optics, the cool and fashion fisheye convex lens gives you the ability to see farther than ever before. The light it gives off is comfortable and bright, and the 8 degree pencil beam design makes it more focused than ever before.

Auxbeam adjustable mounting bracket

light brackets


The installation:

The first thing we need to do was figure out the location to mount the light. Just what I mentioned above, I want to take it for reverse light on the rear of the Jeep Wrangler.

Before that, you need drill bits that are the right size and are sharp, measuring tape and something to mark drill holes would be better if you have.

First, locate both holes and mark them with measuring tape according to the length of the led light bar. Drill holes with drill bit, the hole should be exact size of the mounting bolts. Then put the end brackets included by the led light bar attached to the iron sheet of the rear, tighten them with screws or bolts. To position end brackets properly, attach them to the housing’s end stud. Place the light bar in its final position; tighten them with screws or bolts. Finally, take the taillight on the left side down, connect the wire from the led light bar with harness wiring, the installation is totally completely.

Adjust the direction of the light bar you want, turn on it and text the illumination.

So how bright the light is. Let’s say we were amazed at how bright it was. We know these types of lights are bright, but for its size we were impressed with how much of a difference there was vs our stock headlights.

Scroll down to see the pictures or watch our install video below.

Auxbeam 13.5 inch led light bar

Installation effect



Video of Install:

We think that for only being a 13.5″ light bar, this thing puts out a lot of light. Time will tell how well it holds up, but for right now we are very impressed with the unit.  If you are debating about adding some lights to your Jeep or are looking for a gift idea for the special Jeep owner you know, this one is worth your consideration.

Share this:

Jessica Chen

Hello, my name is Jessica. Thanks for visiting my blog. Here are many detailed descriptions and reviews about Auxbeam LED lights. Browse the blog if you are free, looking for some resources which is helpful to you.