Led Lighting

Auxbeam Blog

Many off road lovers want to get excitement in playing UTVs and they usually drive their UTVs to the forest, deserts or any other... How to Install LED Light Bar on the Grill for UTV

图片1Many off road lovers want to get excitement in playing UTVs and they usually drive their UTVs to the forest, deserts or any other places with faint glow of light. For them, that would be a really big problem. As UTVs are very simple vehicles, most of them do not have enough lights to guarantee things around to be clearly seen by the drivers, which will cause a lot of safety problems. It is of consideration of its seriousness that many drivers choose to add some different kinds of LED lights to support the drivers’ vision. It is simple to install LED light bar on the roof of the UTVs as it is made of rolls. Yet it may be a little hard to install LED light bars on the grill. So here I want to share you some tips on how to install LED light bar on the grill for Polaris RZR.

 

Always remember to disconnect the battery before servicing any fuses or electrical systems.

Mounting bracket

Step 1: Remove the existing lower grille by unscrewing bolts on both side

initpintu_副本

light bar installation process

Step 2: Install the LED light bar in bracket using mount hardware coming with the light. The 1/4 threaded studs on the sides of the light will slide into the slots on the bracket. Don’t fully tighten nuts at this time—you will want to adjust the light angle after it is installed on the vehicle.

step2

light bar installation process

Step 3: Mount the new grille with the light installed where the lower grille was removed. Secure with the original bolts

 

Step 4: Wire your light using the wire harness and switch provided. Take care to avoid any sharp or abrasive surfaces when routing the wire.

 

Step 5: Once your lights are wiring, position your vehicle on a flat surface, facing a wall. Adjust aim on your lights so that the beam is pointing in the vertical direction you want.

555

light bar installation process

 

Share this:

Renee editorrenee

I'm an editor of auxbeam lighting.com. Here in this blog, I will introduce some new products that Auxbeam released and I will also tell you something really hot related to the LED lighting.